LinkRunner™ Duo CE

• Link Verification of Fiber and Copper Circuits at 10/100/1000MBps – Quickly determine if the circuit is up or not.
• Performance Testing with MetroScope and other Popular Test Sets – Use as a remote device for ProVision™, RFC 2544 and other performance tests with testers from Fluke Networks, JDSU, Sunrise, Exfo, and more.
• Layer 1, 2, and 3 Loopback - Configurable loop back to filter frame type and swap MAC and/or IP addresses. Manual or DHCP IP configuration.
• Fiber Power Measurements – Make sure that the incoming signal meets requirements.
• PING Testing – Measure availability and response performance for key devices or URLs.0
• VLAN Verification - Configurable VLAN and priority settings.
• Designed for the Field – Small (fits in a shirt pocket), lightweight (10oz), battery operated and rugged. Operates for over three hours with a removable Li-ion battery pack, four AA batteries, AC or optional car charger (optional).
• Document Results – Save link and ping test results and upload to a PC through the USB port.
• CPE Testing – Pinpoint problems on the customer side with port identification and 802.1x testing, cable and connectivity tests. Verify port settings and troubleshoot speed and duplex mismatch issues.
• Cable Testing – Test cabling and patch cords, including support for toning.
• Media Access - Copper: 10BASE-T, 100BASE-TX, 1000BASE-T (IEEE 802.3), Fiber (SFP): 100BASE-FX, 1000BASE-LX, SX, ZX, BX.
• Easy Upgrades – The mini-USB port on the LinkRunner Duo CE allows software upgrades in the field in jut minutes. And with our Gold support, you’ll automatically receive upgrades at no additional charge. The LinkRunner Connect software also allows you to download reports and capture screen graphics.

"If you’re installing carrier Ethernet, you’ve been forced to choose between thorough testing of the service with a dedicated performance test set or plugging it in and hoping for the best.

Dedicated test sets allow your team to thoroughly test the links. But they can be costly. And “plug and pray” can result in callbacks and extended troubleshooting sessions.

Fluke Networks’ LinkRunner Duo CE Pocket Carrier Ethernet Test Set can reduce your costs and increase customer satisfaction. It’s designed to help technicians quickly turn up and troubleshoot Carrier Ethernet. And, it works with your existing performance testers when you need more complete testing.

Stop the Guesswork
Is it the link or the UNI that’s not working? Quickly verify the link integrity and signal strength. Was the link provisioned properly? Use PING to verify connectivity to expected devices, response time, and VLAN settings. Suspect a customer equipment problem? LinkRunner Duo CE quickly finds speed and duplex mismatches, authentication and addressing problems, and bad ports on copper or fiber.

Get more out of your test sets
Use LinkRunner Duo CE as a remote target for performance testers such as the Fluke Networks MetroScope™ and those from other manufacturers. It supports even the most complex RFC 2544 and ProVision™ tests including multiple streams, TOS and VLAN settings on Layer 1, 2, or 3 network".